samet Smart Slide Full Extension

To Next Page

CABINE

T INTERNA

WIDTH

CABINET

DEPTH

25301740 / 02-15.07.2009

DD = NL - 10

DIW={CIW - 45} ± 0,5

DIW = Drawer Internal Width

CIW = Cabinet Internal Width

DD = Drawer Depth

NL = Nominal Length

Full Extension

Manual

Ø 2

min.41 mm

250

300

350

400

450

500

550

600

* Use angled holes to mount smart lock when wooden

floor width is selected less then 12 mm.

* Slider hole axises can be drilled by using Smart Drilling Jig.

*Pull the “C” handle to displace drawer.Use “B” nut to adjust left-right and

“A” nut to adjust up and down.

* Drawer can be displaced by pulling the “C” handle.

* Install the drawer according to the dimensions above.

* Determine the cabinet internal width and depth before starting the design of

drawer.

* Drill the slide mounting holes.(Use the Smart Drilling Jig with ruler or Smart

Drilling Jig in order to work of drawer properly.)

* Mounting hole axises were given above according to lenght of slide.

* Screw the slider to the cabinet from the holes shown in figure with

chipboard screw Ø3.5x16.

* Drill the Smart lock fixing holes and drawer back holes

by using lock template.

Need help?

Do you have a question about the samet Smart Slide Full Extension and is the answer not in the manual?

Summary

Cabinet Dimension Determination

Drawer Dimension Standards and Installation

Drawer Dimension Definitions

Defines Drawer Internal Width (DIW), Cabinet Internal Width (CIW), Drawer Depth (DD), and Nominal Length (NL) for installation.

Install Drawer by Dimensions

Install the drawer unit precisely according to the specified dimensional guidelines provided.

Cabinet Side Drilling for Slides

Slide Mounting Hole Drilling

Drill slide mounting holes on the cabinet side using a Smart Drilling Jig or ruler for accurate placement.

Slide Mounting Hole Patterns by Length

Hole Axis by Slide Length

Provides mounting hole axes based on the selected slide length for precise installation.

Slider Attachment and Securing

Drill Slider Holes

Use the Smart Drilling Jig to accurately drill slider hole axes for mounting.

Screw Slider to Cabinet

Secure the slider to the cabinet using chipboard screws (Ø3.5x16) through the designated holes.

Smart Lock Installation and Mounting

Drill for Smart Lock

Drill smart lock fixing and drawer back holes using the provided lock template.

Angled Mounting for Narrow Floor Width

Use angled holes for smart lock mounting when wooden floor width is less than 12 mm.

Drawer Adjustment and Operation

Adjusting Drawer Position

Adjust drawer left-right with nut 'B' and up-down with nut 'A'; pull handle 'C' to displace.

Displacing the Drawer

The drawer can be easily displaced or removed by pulling the designated 'C' handle.