SamplexPower RC-15A - LED Display Information; ON;OFF Control Functionality; RJ-12;RJ-25 Modular Jack Pinout

LED Display
The following LED displays are available:
 

lighted. This LED shows that DC input is available to the inverter and that
the input section of the inverter is operating normally
 
output of the inverter has been shut down due to over load
 
output of the inverter has been shut down due to over temperature
ON/OFF Control
ON/OFF Push Button (1) is used to switch ON and switch OFF the inverter.
Pinout Of Rj-12 / Rj-25 Modular jack

at Fig. 2 below:
Fig. 2 Remote Control RC-15A - Pinout of Modular Jack RJ-12 / RJ-25




shown below:
Pinout of Modular jack on
the Remote Control
1
Signal
Pinout of Modular
jack on the inverter
2
1  6
2 Toggle 5
  4
4  
5  2
6  1
1 2 3 4 5 6
LEGEND
LED - “Over Load”
Toggle
Ground
Vbattery
LED - “Power ON”
LED - “Over Temp”
1.
2.
3.
4.
5.
6.
Figure 2 Remote Control RC-15A; Pintout of Modular Jack RJ-12 / RJ-25
1. As shown in Figure 2
2. Mirror image of Remote Control Jack due to crossed-over /rolled over connection of conductors.