SECTION 4 | INSTALLATION
Please refer to Fig. 1. The Remote Control can be ush mounted on a wall or a
SECTION 5 | OPERATION
Please refer to Fig 1. Please also refer to the Owner’s Manual of the inverter for
associated details.
NOTE:
For the Remote Control to operate, the ON/OFF Switch on the inverter
is required to be in ON condition to activate the control circuitry for
the Remote Control.
Switch ON the inverter rst with the help of the Power ON/OFF Switch on the
inverter. The output of the inverter can now be switched OFF/ON by pressing
the ON/OFF Push Button (1).
-
ditions displayed. Read the Owner’s Manual of the inverter for troubleshooting
abnormal conditions indicated by the LEDs.
No Load Current Draw
As stated above, the ON/OFF Switch on the inverter is required to be in ON
Control is turned ON, all the circuitry inside the inverter becomes fully alive and
the AC output is made available. In this condition, even when no load is being
supplied (or, if a load is connected but has been switched OFF), the inverter
and is ready to deliver the required power on demand. This is called the “idle
this Remote Control, some control circuitry is still alive in the inverter and will
require very small current draw. Hence, when the load is not required to be
operated, turn OFF the ON/OFF Switch on the inverter to prevent unnecessary
current drain from the battery.
To Next Page
Loading...
Need help?
General
