Sleeve (ground) Sleeve (ground)Sleeve (ground)
Tip (signal) Tip (signal)
Signal
Unbalanced ¼” Connector to RCA
Ground
Ground
Ground
Ground
Sleeve (ground)Sleeve (ground)
Tip (signal) Tip (signal)SignalSignalSignalSignal
Unbalanced ¼” Connector
GroundGroundGroundGround
Sleeve (ground)Sleeve (ring)Sleeve (ground)
Ring (signal) Signal (tip)
Signal (ring)Tip (signal)
Sleeve (ring)
Signal (tip) Signal (tip)
Signal (tip) Ring (signal)
Tip (signal)Signal (ring)
Balanced TRS ¼” Connector
Solder PointsEnd View
Sleeve (ground)
Cold (3)
Cold (3)
Hot (2)
Common (1)
Male XLR
Signal
Ground
Sleeve (ground)
Signal (tip) Ring (signal)
Tip (signal)Signal (ring)
XLR to Balanced ¼”
Cold (3)Cold (3)
Hot (2) Hot (2)
Common (1)
Male XLR Female XLR
Cold
Solder PointsSolder Points End ViewEnd View
Cold
Hot Hot
CommonCommon Common (1)
XLR to XLR Balanced
Il subwoofer D1200 è dotato di ingressi e uscite bilanciati con connettori XLR e da ¼" (6
mm) normalmente in commercio. Laddove possibile, fare uso di collegamenti bilanciati di
elevata qualità con altre apparecchiature per eliminare le interferenze. Per quanto concerne i
connettori del subwoofer Auro D1200 si veda il diagramma di cablaggio riportato di seguito.
To Next Page
Loading...
