ENGLISH
ESPAÑOLITALIANO FRANÇAISDEUTSCHE
MTR231 Multi-Pattern Studio Condenser Microphone
11
To isolate the MTR231 from external vibrations and prevent unwanted noises that
are transmitted through the stand, the microphone can be fitted on the custom-
designed MSM1 spider shockmount. Follow the steps below to install the micro-
phone into the shockmount.
• Affix the shockmount onto a micro-
phone stand or boom arm. The
shockmount angle can be adjusted
by loosening the thumb screw near
the stand connection.
Note: Do not adjust the angle of
the shockmount without loosening
the thumb screw. If you do this, the
shockmount may be damaged and
you may void your warranty.
• Install the MTR231 into the MSM1
by fitting the microphone into the
center of the web, positioning the
MTR231 onto the bottom mounting
plate with the Samson logo facing
forward.
• Secure the MSM1 by rotating the
threaded collar clockwise until tight.
• Loosen the thumb screw to adjust
the angle of the microphone and
position the MTR231 to the desired
location. Once set, tighten the
thumbscrew to secure the micro-
phone in place.
Note: Be careful not to cross-thread
or over-tighten the threaded collar or
thumb screw.
Shockmount
To Next Page
Loading...
Need help?
General
