Expedition Pro XP100
6
SERVO - 240
SERVO - 240
Using two XP100s in mono: A single mono signal (bus or aux send) is routed from a mixer to a power amplifier. One speaker
output of the power amplifier is connected to
either the XP100 1/4" input (solid line) or Speakon™ input (dotted line), and a con-
nection is made between
either the 1/4" extension to a second XP100’s input (solid line) or between the Speakon™ extension to a
second XP100’s Speakon™ input (dotted line).
Using two XP100s in stereo: A stereo signal (bus or aux send) is routed from a mixer to a power amplifier. The left speaker out-
put of the power amplifier is connected to one XP100 (using
either the 1/4" input [solid line] or Speakon™ input [dotted line]), and
the right speaker output of the power amplifier is connected to the other XP100 (again using
either the 1/4" input [solid line] or
Speakon™ input [dotted line]).
ENGLISH
6
To Next Page
Loading...
