7
Expedition Pro XP200
Guided Tour
1: Input connector - Use this balanced female XLR connector to route line-
level signal into the XP200.
2: Output VU meter - This three-segment bar meter shows the XP200 output
level. For optimum signal-to-noise ratio, set the Volume control (see #6 below)
so that program material is usually at or around 0 VU, with occasional but not
steady excursions to the red “+3 dB” segment.
3: Power switch - Use this to turn power to the XP200 on or off.
4: Voltage selector - Make sure this is set correctly for the country you are in
before turning on the power to the XP200.
5: Battery VU meter - If an optional RB 2030 rechargable battery pack is
installed, this meter shows how much battery power remains as it is being
charged (Power switch off) or depleted (Power switch on).
6: Volume control - This knob sets the level of the XP200’s built-in power
amplifiers.
7: Output connector- This balanced male XLR connector carries line-level out
-
put signal from the XP200. It is used to send signal to a second XP200 being
daisy-chained (see interconnection diagram on the following page) or to an
optional EX500 subwoofer.
8: Limiter switch - Use this switch to turn the built-in limiter circuitry on or off.
In order to maximize speaker protection, we recommend that this switch be left
in the “on” position during normal operation.
9: AC input - Connect the supplied heavy-gauge 3-pin “IEC” power cable here.
Interconnecting the XP200
!
0
10
5
Using one XP200: A single mono signal (bus or aux send) is
routed from a mixer to the XP200 XLR input.
ENGLISH
7
To Next Page
Loading...
