To Next Page

To Previous Page

-5-

Assembling the appliance:

Make sure that the dehydrator sits steadily on a solid level surface. Stock the

drying trays and connect the plug with a wall socket. The dehydrator is now ready

for use.

Using You Dehydrator

1. Put the clean food in the trays – Do not overload the trays and never overlap

the food. Close the door.

2. Plug dehydrator into a wall outlet. The screen and buttons will light up and you

will hear a beep. The screen will show “---“.

3. Press the “ON/OFF” button. The LED screen will show the default time setting

of “10:00” and temp setting of “158F”. The motor and fan start first, then the

heating element will turn on 5 seconds later. The set time will begin to count

down.

4. Press the “TEMP/TIME” button until the LED screen shows the desired time

value. According to actual needs, press “+" or "-" button to change the drying

time between "0:30” and “24:00". Press "+" or "-" button once, the time

increment or decrement is 30 minute/press. If you press and hold the "+" or "-"

button, the time will increase or decrease rapidly. After you finish setting the

drying time, the system automatically starts operating.

5. Press the “TEMP/TIME” button until the LED screen shows the desired temp

value. According to actual needs, press "+" or "-" button to change the drying

temp between "95F” and “167F". Press "+" or "-" button once, the temp

increment or decrement is 9F/press. If you press and hold the "+" or "-" button,

the time will increase or decrease rapidly. After you finish setting the

temperature, the system automatically starts operating.

Note: Set lower temperatures for thin/small pieces of food or for small batches.

Set higher temperatures for drying thick/big pieces of food and large batches.

The thermostat can also decrease the temperature as the food is near the end

Samson SB 1010SS User Manual

Questions and Answers: