Wiring the Mains Power
Supply Plug(UK Only)
IMPORTANT NOTICE
The mains
lead
on
this equipment is suppli
ed
with a moulded
plug
incorporating a fuse. The
value
of
the
fu
se is indicated on the pin face
of
the
plug
and,
if
it requires replacing, a fuse approved
to
BSI1362
of
the same rating must
be
used.
Never use the
plug
with the fuse cover omitted if
the cover is detachable.
If a replacement fuse cover is required, it must
be
of
the same
colour as the pin face
of
the plug.
Replacement covers are
available
from your dealer.
If
the fitted
plug
is
not
suitable for the
power
points
in
your house
or
the
cable
is
not
long
enough
to
reach a p
ower
point, you should
obtain a suitable safety approved extension
lead
or
consult your dealer for assistance. However, if there
is
no alternative
but
to
cut off the
plug, remove
the
fuse and then safely dispose
of
the plug.
Do
NOT
connect the plug
to
a mains socket as there is a risk
of
shock hazard from the bared
flexible
co
rd.
IMPORTANT
The wires
in
the mains
lead
are coloured
in
accordance with the
following
code:
BLUE - NEUTRAL
BROWN -
LIVE
As these colours may not correspond
to
the
coloured markings identifying
the
terminals in your
plug,
proceed as
follows
:
The wire coloured BLUE must
be
connec
ted
to
the
terminal marked with the letter N
or
coloured BLUE or BLACK. The wire coloured
BROWN
must
be
connected
to
the terminal marked with the letter L
or
co
loured
BROWN
or
RED.
WARNING:
DO NOT CONNECT EITHER WIRE TO THE EARTH
TERMINAL, WHICH
IS
MARKED
WITH
THE L
ETTER
E
OR
BY
THE EARTH
SY
MBOL
,
OR
COLOURED
GREEN OR GREEN AND
YELLOW.
Russia Only
- PCT Notice
(@
AB57
MPR
II
Compliance
(MPR
II
applied model only)
Thi
s mo
ni
tor comp
li
es with SW
ED
AC(MPR
II)
recommenda
ti
ons for reduced electric
an
d magne
ti
c fields.
To Next Page
Loading...
