Network
Connection
-
Wired
There are
two
main ways to connect your
TV
to your network using cable, depending on your network setup. They
are
illustrated below:
The
Modem
Port
on
the
Wall
External
Modem
(ADSL
I
VDSL
I
Cable
TV)
~
'?fY~
=i;li;11
.?:J
Modem
Cable
.....
_---------
The
LAN
Port
on
the
Wall
LAN
Cable
1V
Rear
Panel
1V
Rear
Panel
LAN
Cable
IP
Settings
~
A
network
speed of lower then
10
Mbps
is
not
supported.
Configuring
the
Network
Connection
-
Wired
Most home networks use the Dynamic Host Configuration Protocol (DHCP) to configure network connections. Home networks
that support DHCP automatically provide the
IP
address, subnet mask, gateway, and DNS values your
TV
needs to access
the Internet so you
don't
have to enter them manually.
To
configure
your
network
connection
for
a
network
that
uses
DHCP,
follow
these
steps:
1.
Connect your TV to your network as shown
in
one of the
illustrations above.
2.
Turn
on your
TV,
press the
MENU
button on your remote, and
then select the
Network
->
Network
Settings.
3.
Select
Wired.
4.
The network connection screen appears and verifies the
network connection. When the connection has been verified,
the
"Internet
is
connected
successfully."
message appears.
~
If
your TV cannot acquire network the connection values
automatically or
if
you want to set up the connection
manually, select
IP
Settings
on the network connection
screen. Set
IP
Mode
to
Manual.
You
must enter the
IP
Address,
Subnet
Mask,
Gateway, and
DNS
Server
manually.
~
For the detailed information, refer to
"Network
Settings"
in
the e-Manual.
To Next Page
Loading...
