Samsung 7202010 - Name Dialing

67
Contacts List Voice Activation
On startup Nuance reads your Contacts list and voice-activates all the names.
When you have add or change contacts, Nuance automatically reloads and voice-activates the list when you add or
modify a contact.
Name Dialing
To use Name Dial, you need contacts stored in Contacts. For more information, refer to “Using the Contacts List”
on page 34.
To access Voice recognition :
1. In Idle mode, press Menu ➔ Tools ➔ Voice recognition.
2. Say “ Call ” followed by the first and last name of the contact that you want to dial.
The name that you said is repeated through the earpiece and your phone dials the number.
3. If Nuance is not sure of the name that you said, “ Try Again? ” displays on the screen.
4. You are asked to confirm the correct name as Nuance displays the results. Say “ Yes ” or “ No ” to confirm or reject
the number when prompted.
The location repeats through the earpiece and your phone dials the number.
Send Text Message
To access Voice recognition:
1. In Idle mode, press Menu ➔ Tools ➔ Voice Recognition.
After a brief pause, a list of available commands displays on the screen along with the “Say a command” message.
2. Say “ Send Text ” at a distance of 3-8 inches from the microphone. “Say the Name” plays through the earpiece.
3. After you say a name, you might be prompted, “ Did you say send text? ” To confirm a name, wait for the beep and
then say “ Yes .”
4. When the Text Message client launches, compose your text message.
Name Lookup
To perform a name lookup, you have to have some entries in your Contact list.