22 English
Installation
Setting an indoo
r unit address and installation option
SEG1 SEG2 SEG3 SEG4 SEG5 SEG6
0 A 1 - - 3
SEG7 SEG8 SEG9 SEG10 SEG11 SEG12
1 - 1 - 1 B
assign option codes except SEG 1, 7 which are page options.
Setting the installation options in a batch
1 Make sure that the power is supplied to the indoor unit. If the indoor unit is not plugged in, it must include a power
supply.
2 The panel(display ) should be connected to an indoor unit to receive option.
3 Set the installation option according to the installation condition of an air conditioner.
– The default setting of an indoor unit installation option is “02000-100000-200000-300000”.
– Individual control of a remote controller(SEG20) is the function that controls an indoor unit individually when
there is more than one indoor unit.
– No need to assign SEG3, 6, 9, 10, 11, 16, 21, 22, 23, 24 which are non applicable. Even though those segments
are set, they will be ignored.
– If you set the applicable segments with numbers other than the indiciated, the initial setting will be maintained.
4 Set the indoor unit option by wireless remote controller.
Option No. : 02XXXX-1XXXXX-2XXXXX-3XXXXX
Option SEG1 SEG2 SEG3 SEG4 SEG5 SEG6
Explanation PAGE MODE
RESERVED
Use of external
temperature sensor
Use of central control
RESERVED
Indication and
details
Indication Details Indication Details Indication
Details Indication
Details
0 2
0
Disuse 0
Disuse
1 Use 1 Use
Option SEG7 SEG8 SEG9 SEG10 SEG11 SEG12
Explanation PAGE Use of drain pump
RESERVED RESERVED RESERVED
Group address
Indication and
details
Indication Details Indication Details Indication
Details
1
0
Disuse
0
slave
1
Use
1
master
2
Use +
3minute
delay
To Next Page
Loading...
