Disassembly and Reassembly
3-68 Samsung Electronics
No Parts Procedure Remark
2 CONTROL-IN
7) Unfasten a screw of the Ground wire and
pick up Temperature wires from ASSY
EVAP.
(Use (+) Screw Driver.)
8) The CONTROL-IN is fixed to HOLER
PIPE by a hook bottom of the case as
shown in the last figure. (Please loosen
remaining connectors before detaching
CASECONTROL.
Caution:
When you separate the connector, pull
pressing the locking button
9) Put down of the HOLDER PIPE and push
up the hook and lean side the case as
shown in figures.
To Next Page
Loading...
