Troubleshooting
Samsung Electronics 4-9
The procedure of setting option (Cont.)
Steps Remote control display
19
a
b
Step 4
Point the remote control to the remote control sensor onthe indoor unit and then press the (Power) button onthe remote
control twice. Make sure that this command is received by the indoor unit.
When it is successfullyreceived, you can hear a short sound from the indoor unit. If the command is not received,
press the
(Power) button again.
Step 5
Check whether the air conditioner operates in accordance with the option values you have set:
a Reset the indoor or outdoor unit.
•
Indoor unit : Press the (Set) and (Option)buttons on the remote control simultaneously for 4 seconds.
• Outdoor unit : Press the K3 button.
b
Remove the batteries from the remote control,insert them again, and then press the
(Power) button on the
remote control.
Check whether the option values that you have set are correct by pressing the
(Mode) button repeatedly
Step 3
To Next Page
Loading...
