Disassembly and Reassembly
3-110 Samsung Electronics
No. Parts Procedure Remark
12
4 Way Valve
1) First, discharge the refrigerant.
2) Remove the 2 screw which is fixed to
Service Valve. (Use +Screw Driver)
3) Separate the inlet and outlet pipes
by welding torch.
If you separate the Compressor,
Heat Exchanger or Pipe, please
fully discharge refrigerant in the
Compressor and then separate the
Pipe by welding torch.
13
EEV Valve
1) Remove the 2 screws which is fixed
to Service Valve and separate it. (Use
+Screw Driver)
2) Separate the inlet and outlet pipes
by welding torch
To Next Page
Loading...
