Disassembly and Reassembly
3-114 Samsung Electronics
No Parts Procedure Remark
6 Ass'y control
out
1) Disconnect and Separate 5 Connectors
of wire from Assy Control Out.
2) Separate Comp wire and Reactor wire
from each object.
(When you disconnect BLDC motor
connector you have to cut the power
off first and disconnect 30 seconds
later And Make sure that is impossible
to connect and disconnect BLDC
motor connector when the power is on)
3) Unscrew and remove 2 screws on of
Assy Control out.
To Next Page
Loading...
