Samsung AC026FCADEH - Way Cassette Type

4-14 Samsung Electronics
4-2-4 1 way cassette type
㽞 Error detection and reoperation
1. If an error occurs during operation, the LED flashes to indicate that there is a problem then all operations stop except LED.
2. When resuming operation with remote controller and switch, it determines error mode after normal operation.
㽞LED lamp display when error is detected
Error LED lamp Display
Cause Actions to take
Operation Defrost
XX
䢻
XX
• Breakaway from the room temperature
sensor connector.
• Cut the room temperature sensor wire.
• Check the connection between the room tem-
perature wire and the main PCB of the indoor
unit.
• Check the pattern of the room temperature sen-
sor part of the main PCB of the indoor unit and if
parts are open or shorted.
䢻
X
䢻
XX
• Disjoint of the in/out sensor connector
of the indoor heat exchanger.
• Cut the in/out sensor wire of the
indoor heat exchanger.
• Check the connection between the room tem-
perature wire and the main PCB of the indoor
unit.
• Check the pattern of the room temperature sen-
sor part of the main PCB of the indoor unit and if
parts are open or shorted.
XXX
䢻
X
• Indoor fan motor is non-operative.
• Indoor fan motor is operating
slowly.
• Indoor fan motor operates at an exces-
sive speed.
• Check if a motor connector has been
dismounted. (CN44. CN73)
• Check the fastening of the motor fan.
䢻
XX
䢻
X
• Disjointed or cut off of outdoor tem-
perature sensor.
• Disjointed or cut off of the outdoor
sensor of heat exchanger (COND).
• Dismounted/cut off of the outdoor
discharge sensor.
• Check the PCB display window of the outdoor
unit then refer to a breakdown diagnosis.
XX
䢻䢻
X
• Communication error between indoor
units and outdoor units for more than
2 minutes.
• 3 min. error of the outdoor unit track-
ing. (multi-product specification)
• Inconsistency between the number
of installed units and communication
units. (multi-product specification)
• Check the connection between indoor and out-
door units
• Check the settings for indoor Main/RMC address
switch
XX
䢻䢻䢻
• The detection of secondary high tem-
perature at COND.
(outdoor heat exchanger)
• The detection of secondary high tem-
perature at discharge.
• Reverse detection error.
• Check the PCB display window of the outdoor
unit then refer to breakdown diagnosis.
XXX
䢻䢻
• Deviation of float sensor connector.
• Cut of float sensor wire.
• Check the connection between main PCB and
float sensor in the indoor unit.
لTurn onስFlashingΉTurn off