When installing the outdoor unit near seashore, make sure it is not directly exposed to sea breeze. If you can not nd a
adequate place without direct see breeze, protection wall should be constructed.
• You have just purchased a system air conditioner and it has been installed by your installation specialist.
• This device must be installed according to the national electrical rules.
• With an outdoor unit having net weight upper than 60kg, we suggest do not install it suspended on wall,
but considering oor standing one.
• When the outdoor unit is installed near seashore or in a place where sulfuric acid gas may leak, corrosion
may occur in outdoor unit and cause product malfunction.
Install the outdoor unit in a place (such as near buildings etc.) where it can be prevented from sea breeze which
can damage the outdoor unit.
If you cannot avoid installing the outdoor unit by the seashore, construct a protection wall around to block the
sea breeze.
•
Protection wall should be constructed with a solid material
such as concrete to block the sea breeze and the height and the
width of the wall should be 1.5 times larger than the size of the
outdoor unit. Also, secure over 700mm between the protection
wall and the outdoor unit for exhausted air to ventilate.
Install the outdoor unit in a place where water can drain smoothly.
If you cannot nd a place satisfying above conditions, please contact manufacturer. Make sure to clean the sea
water and the dust on the outdoor unit heat exchanger and spread corrosion inhibitor on heat exchanger. (At
least one time per one year.)
Depending on the condition of power supply, unstable power or voltage may cause malfunction of the parts or
control system.(At the ship or places using power supply from electric generator, etc).
Outdoor unit
Sea breeze
Sea
Outdoor unit
Sea breeze
Sea
Outdoor unit
Sea breeze
Sea
Protection wall
To Next Page
Loading...
