Interface module Installation (Optional)
Interface module
Interface module
power cable
Interface module
communication cable
Installation Manual Case Cable-tie
Fix the case with hinges
(Control Box in the outdoor unit)
✴
026/035/052
✴
✴
052/060/071
✴
Fix the case with hinges
(Control Box in the outdoor unit)
Accessories (Interface module : MIM-B13D)
1. Fix the case at with bolts on the side of the control box in the outdoor unit.
(See the picture)
2. Attach the Interface module PCB to the case in the control box in the
outdoor unit, then connect the power and the communication cable
between the Interface module and the outdoor unit; refer to the gure of
pages 13.
3. If you install a Interface module to an outdoor unit, every indoor unit which
is connected to an outdoor unit can be controlled simultaneously.
4. Each outdoor unit connected to the same centralized controller has its own
Interface module.
To Next Page
Loading...
