E-29
Setting an indoor unit address and installation option(Continued)
AM
FBFDEH
Series
※ The designs and shape are subject to change according to
the model.
1
Before installing the indoor unit, assign an address to the indoor unit accord-
ing to the air conditioning system plan.
2
The address of the indoor unit is assigned by adjusting MAIN(SW01, SW02)
and RMC(SW03, SW04) rotary switches.
Setting Main Address
The MAIN address is for communication between the indoor unit and
the outdoor unit. Therefore, you must set it to operate the air conditioner
properly.
You can set the MAIN address from ‘00’ to ‘99’ by mixing SW01 and SW02.
The MAIN address from ‘00’ to ‘99’ should differ from each other.
Check the indoor unit address on the plan that you are to install and set
the address according to the plan.
You may not need to set main address if you selected
Auto Address Setting from the outdoor unit: see details
on the outdoor unit installation manual.
Note
For Example
When MAIN address is set as “12”.
Setting RMC Address
The SW03 and SW04 RMC switch is the address setting switch for
controlling the indoor unit with the centralized controller.
You must set the SW03, SW04 and K2 switch when using the centralized
controller.
You don’t have to set the SW03 and SW04 RMC switch when not using the
centralized controller.
SW03 SW04
For Example
When RMS address is set as “12”.
NASA_Floor Stand_AM@@@FNFDEH@_IM_EN_03678A-05.indd 29 2016-05-09 오후 5:32:40
To Next Page
Loading...
