E-6
Concrete
Hole for
anchor
or plug
Fixing bolt (Φ9.52 or M10)
Indoor Unit installation
Refrigerant pipe work must be done before installing the indoor unit.
Check the product and the location where it will be installed.
Check the required installation conditions.
Drill a hole on a floor or a wall and insert bolt anchors as shown in the figure.
- Use a Φ9.52 or M10 bolts for installation.
- At least 2 anchor bolts must be used for fixing the indoor unit.
Select a location with no obstacles in surrounding area while allowing easy
pipe and electrical installation, and also consider a place where it may not fall
or get shaken by vibration or any other external force.
Drill a hole for the drain on the bottom or rear side of the indoor
unit with a diameter between 60~65mm.
Make sure that product is in level.
- Check the horizontality by using a level or a vinyl tube with water etc.
Fix the indoor unit by connecting it to the anchor bolt.
1
2
3
4
5
6
7
All the part must be purchased separately.
Service space must be secured.
If the indoor unit is not installed in level, drain water may get in to
the indoor unit due to incorrect measurement of water level.
NASA_Floor Stand_AM@@@FNFDEH@_IM_EN_03678A-05.indd 6 2016-05-09 오후 5:32:29
To Next Page
Loading...
