Samsung AQ12T Series - Using the Auto Clean Function

16
Using the Auto Clean function
Auto clean function will prevent from growing mold by eliminating the moisture inside of the indoor unit. Your indoor unit
evaporates the moisture inside of the unit. Activate this function to provide you with more clean and healthier air.
Press the Auto Clean button.
• When the air conditioner is turned on, the Auto clean function runs after
stopping the air conditioner operation.

The Auto clean indicator on the indoor unit display appears and the Auto cleaning
function runs.
When the air conditioner is turned on,

The Auto clean indicator on the indoor unit display appears and the Auto cleaning
function runs after stopping the air conditioner operation.
Press the Auto Clean button once again. Cancel
※
Auto Cleaning time can vary, depending on the previously used mode.
Auto(cool), Cool, Dry mode : approximately 30 minutes.
Auto(heat), Heat, Fan mode : approximately 15 minutes.
•
lighting in Auto clean mode
Using the Quiet function
You can reduce the noise generated from an indoor unit.
Press the Quiet button on the remote controller while the air conditioner is operating
in Cool/Heat mode.

Quiet indicator appears on the remote controller display.

The indoor unit will operate more quietly.
• If using a multi system, this function will work only when the Quiet function is
set on all operated indoor units.
Press the Quiet button once again.Cancel