36
Cleaning
English
Cleaning and MaintenanceCleaning and Maintenance
Cleaning the PM 1.0 filter
Clean the PM 1.0 filter every 3 months. The time between cleanings may vary, depending on the usage
and environmental conditions.
CAUTION
• Unplug the power plug for safety when cleaning PM 1.0 filter.
• The inside surface of the PM 1.0 filter is sharp. Be careful not to cut your hand.
• When cleaning the PM 1.0 filter, do not disassemble it.
NOTE
• If the filter is very dirty, immerse the filter in the water in which a neutral detergent is dissolved for 30 minutes,
then rinse the filter until it is not dirty.
• Dry the PM 1.0 filter completely by leaning vertically against the wall avoiding the direct sunlight in the shade for
12 hours.
• To close the cover, pull stopper frontward.
Stopper
To Next Page
Loading...
