Samsung AR18CSFCMWKNCV - Page 36

36
NO. Parts Procedure Remark
3 Assy
Control Out
1) To remove the Cover control box :
Pull the motor wire is allow
sufcientspaceasshownonthe
right side and then remove the
screw.
2) Detach several connectors from
the Assy Control Out.
3) Detach several connectors from
the PCB of Assy Control Out.
1)Releasetherefrigerantatrst.
2) Loosen ng screw on both sides.
3) Disassemble the pipes in both
inlet and outlet with welding torch.
4) Detach the Heat Exchanger.