Samsung AR18CSFCMWKXCV - Page 49

49
No. Parts Procedure Remark
10 Bracket Motor 1) Remove the 2 screws from
the Bracket Motor and separate
it.(Use+ScrewDriver)
11 Control Out 1) Disconnect 6 Connecters
From Ass’y Control Out.
2) Unscrew and remove 4
mounting screw on Control Out.
(Use+ScrewDriver)
3) Separate Ass’y Control Out.
12 4 Way Valve 1) First, discharge the
refrigerant.
2) Remove the 2 screws which
isxedtoServiceValveand
separate it. (Use
+ScrewDriver)
3) Separate the inlet and outlet
pipes by welding torch.
!CAUTION : If you separate the
Compressor, Heat Exchanger
or Pipe, please fully discharge
refrigerant in the Compressor
and then separate the Pipe by
welding torch.