Samsung AR18HSFSJWKN - Settings; Using the Auto clean function; Setting the Beep sound

Using the Auto clean function
Auto clean function will minimise the moisture inside of the indoor unit. Activate this function to help provide you with clean air.
When the air conditioner is operating;
Indoor unit display
1. Press the Settings button.
2. Press the
, or Settings button until (Clean) indicator starts to blink.
3. Press the SET button to set the Auto clean function.
- 3 seconds after setting Auto clean function, (Clean) indicator on the remote
controller display will disappear and Auto clean (
), Timer ( ) indicator will
turn on the indoor unit display. Auto clean function will be activated after the air
conditioner stops operating.
- Duration of the Auto clean function can be dierent depending on the previous
operation mode used.
Auto(cool), Cool, Dry mode : 30 minutes.
Auto(heat), Heat, Fan mode: 15 minutes.
Cancel
f Press the Settings button  Press the , or Settings button to
make the (Clean) indicator blink and press the SET button.
t When the operation mode is set during Auto clean function is activated,
the air conditioner will operate in chosen operation mode and the Auto
clean function will be re-activated when the operation stops.
t %VSJOHUIFBVUPDMFBOGVODUJPOJOEPPSGBOXJMMDPOUJOVFUPSVOBOEBJS
ow blade will remain open to allow the indoor coil to dry.
AR77JS/HSSD77
AR77HSFSJWK7
AR77HSFSHWK7
Setting the Beep sound
Beep sound from the indoor unit can be muted.
1. Press the Settings button.
2. Press the
, or Settings button until (Beep) indicator starts to blink.
3. Press the SET button to mute the beep sound.
- 3 seconds after setting Beep sound function, (Beep) indicator on the remote
controller display will disappear and Beep sound function will begin.
English-25
SETTINGS05
AR5000&A3050 CV HP_IB&IM_DB68-04937A_EN.indd 25 2015/1/4 11:48:05