Samsung AR18HSFSJWKN - Page 44

2 . Open the cover panel.
3 . Remove the screw securing the connector cover.
4 . Pass the assembly cable through the rear of the indoor unit and connect the assembly cable to terminals.
(Refer to the picture below)
t &BDIXJSFJTMBCFMFEXJUIUIFDPSSFTQPOEJOHUFSNJOBMOVNCFS
5 . Pass the other end of the cable through the 2.56inch(65mm) hole in the wall.
6 . Close the connector cover by tightening the screw carefully.
7 . Close the cover panel.
8 . Remove the terminal board cover on the side of the outdoor unit.
9. Connect the cables to the terminals as seen in the picture.
t &BDIXJSFJTMBCFMFEXJUIUIFDPSSFTQPOEJOHUFSNJOBMOVNCFS
Indoor unit
Outdoor unit
t "MTPDJSDVMBSUFSNJOBMNVTUCFNBUDIFEXJUITDSFXTJ[FJOUFSNJOBMCMPDL
t "GUFSDPOOFDUJOHUIFDBCMFTNBLFTVSFUFSNJOBMOVNCFSTPOUIFJOEPPSPVUEPPSVOJUNBUDIFT
t 1MFBTFFOTVSFUIBU1PXFS$PNNVOJDBUJPODBCMFTBSFTFQBSBUFEUIFZNVTUOPUCFJOUIFTBNFDBCMF
t
10. Connect the grounding conductor to the grounding terminals.
11. Close the terminal board cover by tightening the screw carefully.
t *O3VTTJBBOE&VSPQFDPOTVMUXJUIUIFTVQQMZBVUIPSJUZUPEFUFSNJOFUIFTVQQMZTZTUFNJNQFEBODFCFGPSF
installation.
t $POOFDUUIFXJSFTöSNMZTPUIBUXJSFTDBOOPUCFQVMMFEPVUFBTJMZ
(If they are loose, it could cause burn-out of the wires.)
t $POOFDUUIFXJSFTBDDPSEJOHUPDPMPSDPEFTSFGFSSJOHUPUIFXJSJOHEJBHSBN
t 5IFQPXFSDBCMFBOEUIFJOUFSDPOOFDUJPODBCMFTIPVMECFTFMFDUFEBDDPSEJOHUPUIFTQFDJöDBUJPOJOQBHF
L1
L2
F1
F2
L1
L2
F1
F2
L1
L2
F1
F2
L3
L4
L3 L4
F1
F2
L3
L4
F1
F2
L1 L2
F1
F2
Indoor unit
Outdoor unit
Indoor unit
Outdoor unit
7709/12/1877
772477
1. Extend the assembly cable if necessary.
t %POPUDPOOFDUUXPPSNPSFEJòFSFOUDBCMFTUPFYUFOEUIFMFOHUI
It may cause re.
Connecting the wiring
English-44
AR5000&A3050 CV HP_IB&IM_DB68-04937A_EN.indd 44 2015/1/4 11:48:15