Troubleshooting
4-12 Samsung Electronics
4-3-1 Setting Option
1 Remove batteries from the remote controller
2 Insert batteries and enter the option setting mode while pressing ❷ button and ❸ button.
3 Each time you press ❺ button, 7-seg on left side is increased by “1” and each time you press ❹ button,
7-seg on right side is increased by “1”
4 You press ❶ button to move to the next setteing page.
5 After setting option, press ❶ button to check whether the option code you input is correct or not.
→ → → →
→ → → →
6 Press operation button with the direction of remote control for set.
• SEG1, SEG7, SEG13, SEG19 are not set as page option.
• Set the SEG1, SEG7 as ON status and SEG13, SEG19 as OFF status.
option at the same time.
CAUTION
4-3-2 The procedure of setting option
Operation Indication
Step 1
1 Remove the batteries from the remote controller.
2 Insert batteries while pressing ❷ Button and ❸ Button.
Step 2
1 Press ❺ button to enter SEG2 value.
2 Press ❹ button to enter SEG3 value.
Step 3
Press ❶ button to be change to Cool mode in the ON status.
1 Press ❺ button to enter SEG4 value.
2 Press ❹ button to enter SEG5 value.
Step 4
Press ❶ button to be changed to DRY mode in the ON status.
1 Press ❺ button to enter SEG6.
2 Press ❹ button to enter SEG8.
Step 5
Press ❶ button to be changed to FAN mode in the ON status.
1 Press ❺
2 Press ❹ button to enter SEG10 value.
To Next Page
Loading...