Samsung AR18TSFABWKN - Changing the Addresses and Option Individually

Troubleshooting
Samsung Electronics 4-29
4-3-5 Changing the addresses and option individually
When you want to change the value of a specific option, refer to the following table and follow the steps in
Common steps for setting the addresses and options on page 18.
Option SEG1 SEG2 SEG3 SEG4 SEG5 SEG6
Function Page Mode
Type of the option
to change
Tens position
of the option
number
Units position
of the option
number
New value
Indication
and details
Indication Details Indication Details Indication Details Indication Details Indication Details Indication Details
0 D
Option
type
0 to F
Tens
position
value
0 to 9
Units
position
value
0 to 9
New
value
0 to F
Example: Changing the Buzzer control (SEG17) option of the installation options to 1 disuse.
Option SEG1 SEG2 SEG3 SEG4 SEG5 SEG6
Function Page Mode
Type of the
option to change
Tens position
of the option
number
Units position
of the option
number
New value
Indication
0 D 2 1 7 1
• If your indoor units support both cooling and heating, the mixed operation (two or more indoor units operate in
different modes simultaneously) is not available when the indoor units are connected to the same outdoor unit.
If you set an indoor unit as the master indoor unit by using the remote control, the outdoor unit automatically
operate in the current mode of the master indoor unit.
CAUTION