7
No Parts Procedure Remark
Heat Exchanger
Compressor
4) Remove the nut flange (Turn to the right to
remove, as it is a left hand screw)
5) Separate the fan.
6) Loosen four fixing screws to separate the motor.
1) Do “1”, above.
2) Loosen three fixing screws of left and right
side.
3) Disassemble the inlet and outlet pipe by weld-
ing.
4) Separate the heat exchanger.
1) Do “1”, above.
2) Open the terminal cover of compressor and
unscrew the connection terminal.
3) Disassemble the inlet and outlet pipe of com-
pressor by welding.
4) Disassemble the inlet and outlet pipe of con-
denser by welding
5) Loosen the three bolts of the lower part.
6) separate the compressor.
3
4
1- 5/14/01 8:55 PM Page 7
To Next Page
Loading...
Need help?
General
