Samsung BN68-01700A-00

Questions and Answers

D
David JohnsonAug 6, 2025
What to do if the connected device is not displayed on my Samsung BN68-01700A-00 LCD TV using Anynet+?
- G
  Gary BlairAug 6, 2025
  If the connected device isn't displayed, verify the following: * Confirm that the device supports Anynet[+] functions. * Check that the HDMI 1.3 cable is properly connected. * Ensure Anynet[+] (HDMI-CEC) is set to On in the Anynet[+] setup menu. * Try searching for Anynet[+] devices again. * Use only an HDMI 1.3 cable to connect an Anynet[+] device, as some HDMI cables may not support Anynet[+] functions. * If the connection was terminated abnormally (e.g., disconnecting the HDMI cable or power cord, or a power failure), repeat the device scan.
Z
Zachary FrederickAug 13, 2025
How to start Anynet+ on a Samsung LCD TV?
- K
  katherine41Aug 14, 2025
  To start Anynet+, ensure the following: * The Anynet+ device is properly connected to the TV. * Anynet[+] (HDMI-CEC) is set to On in the Anynet[+] Setup menu. * Press the TV button on the TV remote control to switch to TV. Then press the TOOLS button to show the Anynet[+] menu and select a menu you want.
P
Patrick JimenezAug 21, 2025
How to exit Anynet+ on my Samsung BN68-01700A-00?
- J
  joshua34Aug 21, 2025
  To exit Anynet[+], you can: * Select View TV in the Anynet[+] menu. * Press the SOURCE button on the TV remote control and select a device other than Anynet+ devices. * Press P >/< and PRE-CH to change the TV mode.
H
Heather MccarthyOct 29, 2025
Why is Anynet+ not working on my Samsung BN68-01700A-00?
- J
  Jessica HortonOct 29, 2025
  If Anynet+ is not working, consider these points: * Ensure the device is an Anynet+ compatible device, as the system supports only Anynet[+] devices. * Connect only one receiver (home theater). * Verify that the Anynet[+] device's power cord is properly connected. * Check the Video/Audio/HDMI 1.3 cable connections of the Anynet[+] device. * Confirm that Anynet[+] (HDMI-CEC) is set to On in the Anynet+ setup menu. * Make sure the TV remote control is in TV mode. * Verify it is an Anynet[+] exclusive remote control. * Note that Anynet+ might not function during Searching channels, Operating WISELINK Pro, or Plug & Play. * When connecting or removing the HDMI 1.3 cable, search for devices again or turn your TV off and on. * Ensure the Anynet[+] Function of the Anynet[+] d...