15
Upgrading the Software via USB
1
Be sure to insert the USB disk into the USB port marked out with the blue box as shown in the
figure below. You can upgrade the software via USB only if either the monitor screen operates
normally or the check signal is displayed on the monitor screen.
USB
Check Signal Cable
HDMI
When the screen as shown in the following figure is displayed, press and hold the Down arrow key
for 5 seconds.
Power Off
2
When the message as shown in the following figure is displayed on the monitor, select Yes to
upgrade the software.
Do you want to update via USB?
YesNo
3
When the screen as shown in the following figure is displayed, select Yes.
Update from version 0802.0 to version 0803.0
Update now
YesNo
4
The software upgrading proceeds.
Updating product Software...
Your product will turn itself off and on again
automatically after completing update.
Update now
0%
To Next Page
Loading...
Need help?
General