21
Removing the Stand (For Attaching the BRACKET WALL)
―
Before removing the stand from the monitor, place the monitor on a flat and stable surface with the screen facing down.
: The product is curved. Placing pressure on the product when on a flat surface may damage the product. When the product is on the ground facing up or down, do not put pressure on it.
1
2
3
4
Rotate the COVER-REAR TOP counterclockwise. Lift the COVER-REAR TOP. Disassemble the COVER-REAR TOP. Remove the stand base from the stand neck.
5 6
Unfasten the 4 screws at the top of the stand neck. Lift and remove the stand. Caution
Do not press down on the monitor. There is a risk
of damaging the monitor.
To Next Page
Loading...
