Disassembly and Reassembly
Service Manual
3-2
Samsung Electronics
3.2 Parts for Maintenance and Repair
3.2.1 Replacement interval for parts with a limited life
Some of the parts in this printer have a limited life, shorter than that of the whole machine. These parts must
be replaced periodically.
The table below shows the interval at which these parts should be replaced.
The table shows the life of each part, and is measured when using A4 paper. When servicing a machine
always check the status of these parts using the control panel and ensure that parts are replaced at the
appropriate times otherwise a general degradation in print quality will occur.
Item Pages Printed Part number Remark
Black Toner cartridge
Approx. Initial : 1,000 Pages*
Sales : 1,500 Pages*
CLT-K409S(Black) CRU
Color Toner cartridge
Approx. Initial : 700 Pages*
Sales : 1,000 Pages*
CLT-C409S(Cyan)
CLT-M409S(Magenta)
CLT-Y409S(Yellow)
Imagine unit Approx. 24000 images* CLT-R409
Waste Toner Approx. 2500 images CLT-W409
Pick-up roller Approx. 50,000 pages JC97-03028A FRU
Fuser unit Approx. 100,000 black pages or 25,000
color bages
JC96-04781A (110V)
JC96-04780A (220V)
T2 roller Approx. 10,000 pages JC97-03046A
ITB Approx. 100,000 black pages or 25,000
color bages
JC96-04840A
* Average A4-/letter-sized page count based on Std. 19752 of individual colors on each page. Usage conditions and print
patterns may cause results to vary.
** Image counts based on one color on each page. If you print documents in full color (Cyan, Magenta, Yellow, Black),
the life of this item will be reduced by 25%.
To Next Page
Loading...
