Alignment & Troubleshooting
Service Manual
4-12
Samsung Electronics
4.1.6.3(a) Motor Test
Item Discription
Main Motor If motor lock signal is normal, “Successed” message will be displayed.
When motor lock signal is abnormal, “failed” message will be displayed.
When “Upper Level” is pushed, “off” message will be displayed.
4.1.6.3(b) Solenoid Test
Item Discription
Dev Clutch When “select” key is pushed, “Dev Clutch ON” message will be displayed. “Upper Level” is
pushed, ”Dev Clutch Off” message will be displayed.
Relay 1 When “select” key is pushed, “1 Relay ON” message will be displayed. “Upper Level” is
pushed, ”1 Relay Off” message will be displayed on.
Relay 2 When “select” key is pushed, “2 Relay ON” message will be displayed. “Upper Level” is
pushed, ”2 Relay Off” message will be displayed.
Relay 3 When “select” key is pushed, “3 Relay ON” message will be displayed. “Upper Level” is
pushed, “3 Relay Off” message will be displayed.
Y Toner When “select” key is pushed, “Y Toner ON” message will be displayed. “Upper Level” is
pushed, “Y Toner Off” message will be displayed.
M Toner When “select” key is pushed, “M Toner ON” message will be displayed. “Upper Level” is
pushed, “M Toner Off” message will be displayed.
C Toner When “select” key is pushed, “C Toner ON” message will be displayed. “Upper Level” is
pushed, “C Toner Off” message will be displayed.
K Toner When “select” key is pushed, “K Toner ON” message will be displayed.“Upper Level” is
pushed, “K Toner Off” message will be displayed.
Regi Clutch When “select” key is pushed, “REGI Clutch ON” message will be displayed. “Upper Level” is
pushed, “REGI Clutch Off” message will be displayed.
T2 Clutch When “select” key is pushed, “T2 Clutch ON” message will be displayed. “Upper Level” is
pushed, “T2 Clutch Off” message will be displayed.
ITB Clutch When “select” key is pushed, “ITB Clutch ON” message will be displayed. “Upper Level” is
pushed, “ITB Clutch Off” message will be displayed.
Tray1 Clutch When “select” key is pushed, “Tray1 Clutch ON” message will be displayed. “Upper Level” is
pushed, “Tray1 Clutch Off” message will be displayed.
Tray2 Clutch When “select” key is pushed, “Tray1 Clutch ON” message will be displayed. “Upper Level” is
pushed, “Tray1 Clutch Off” message will be displayed.
Regi. Sensor If actuator is checked by sensor, “Without Paper” message will be displayed.
if not, “With Paper” message will be.
Exit Sensor If actuator is checked by sensor, “Without Paper” message will be displayed.
if not, “With Paper” message will be.
Waste Box If waste Box exists , “Installed” message will be displayed.
If not, “Not Installed” message will be.
To Next Page
Loading...
