Samsung CM1919 - Fuse and Drive Motor Replacement

18
ENGLISH
REPLACEMENT OF LAMP
Important
1. Remove a screw securing the lamp cover.
You don’t need to remove outer panel to replace lamp.
2. Remove the lamp by rotating it clockwise.
3. Replace with a new lamp by rotating it counter-clockwise.
INSTALLATION INSTRUCTIONS FOR STACKING
Important
1. Disconnect the power cord from the wall socket before attempting
installation.
2. For stacking installation, you must use the “bracket plate” which is
enclosed with this unit.
3. The maximum stacking height is two units.
Stacking the two units is limited to the following models.
CAUTION :Besuretheovencavityisempty.
Installation
1. Stack two units together.
2. Remove 6 screws as shown in the figure.
3. PlacetheBracket-platetojointhetwounits.
4. Attach and tighten 6 screws as shown in the figure here.
5. Ensure the top oven is at a safe and workable height.
Screw
Bracket-Plate
Outer
Panel
Lamp
Cover
Lamp Holder
Lamp
(230V 25W)
CM1919_SA_DE68-04029C_EN.indd 18 9/27/2013 4:48:38 PM