Samsung CP1395E-S - Page 34

- 32 -
NO
NO
NO
YES
YES
YES
YES
NO
Initial Temperature Error
(at MW mode), (E-25)
S/W Error
Replace the PCB.
RY603V : Direct current 12 ~ 14V
is normal
Perform the operation again and check if it
is working properly.
Is the oven in MW mode?
Is the internal temperature
over 200 degrees?
Is the sensor connectivity
normal?
An “E-25” error
occurred.
Press the Cancel key.
Connect it
properly
and try again.
After Power > On,
does the symptom continue?
Press the Cancel
key to cancel the
current state.
Perform the calibration
(Refer to page 18)
4-3-5 E-25