Samsung CP1395EST - Page 35

- 33 -
“E-37,E-38,E-39” is displayed
Has the turntable been placed
over the support-tray properly?
NO
NO
NO
YES
YES
YES
Do you have a problem
on calibration?
Placed the turn table
over the support-tray properly
Perform the calibration
(Refer to page 18)
Perform the calibration
(Refer to page 18)
Replace the PCB.
Replace the assy-weight sensor
Perform the operation again and
check it is working properly
Do you have same problem?
S/W Error.
Perform the operation again and
check it is working properly
Doyou have same problem?
YES
4-3-6 E-37 , E-38 , E-39