Disassembly & Reassembly
3-2 Samsung Electronics
3-1-2 Disassembling the CRT and Chassis
Part Name Description Description Photo
Chassis
Holder
①
Separate the Ass’y Holder chassis from the Front
Cabinet.
②
Pull the Holder Chassis while pushing the catch up.
If you pull it with excessive power, it may cause
damage to the catch or connector. Therefore, pull it
until the catch is out of the hole.
Pull the chassis while pushing the
clip fixing the Front Cabinet and
the Holder Chassis.
①
Separate the CRT connection, the TBC wire,and the
the speaker connection.
Since there is a hinge fixing the Wire Connector and
Connector Header, if the wire is pulled with excessive
power, it may damage the catch or connector.
Therefore, pull it only after pressing the hinge down
completely.
Pull the chassis while pushing the
clip fixing the Front Cabinet and
the Holder Chassis.
①
Separate the D-Coil, DY-Cable and power cord from
the Front Cabinet and Main Board.
②
Separate the power cord, DY-Cable by pushing the
fixing catch to the side and pulling the wire up.
Pull the chassis while pushing the
clip fixing the Front Cabinet and
the Holder Chassis.
①
Separate the CRT Ass’y from the CRT.
②
Separate the TBC wire, GND cables from the
CRT Ass’y sequentially.
Pull the chassis while pushing the
clip fixing the Front Cabinet and
the Holder Chassis.
To Next Page
Loading...
