Disassembly & Reassembly
12-4 Samsung Electronics
Part Name Description Description Photo
CRT Ass'y
① Separate the cables from the Main Board and CRT Ass'y.
① Separate the wires from the FBT of the Main Board and the
CRT Ass'y.
② To separate the thick red wires, pull the wires while pressing
the push-type clip at the connector.
③ To separate the thin red wire, insert a pin in the small hold
next to the hole and pull the wire.
Notice: Take care when separating the wires because pulling
the wires by force may damage the socket. In addition, sepa-
rate the wires on a flat and clean surface so as to prevent
scratching of the material and the PCB.
12-1-3 Disassembling the CRT Ass'y
To Next Page
Loading...
