Samsung CS3339Z4C - Page 18

Alignment and Adjustments
4-12 Samsung Electronics
4-2-4 (I) TTX MICOM (SPM-193EA2) OPTION TABLE (FOR MIDDLE EAST ASIA/AFRICA)
BYTE
B
Y
T
E
0
B
Y
T
E
1
BIT
D7
D6
D5
D4
D3
D2
D1
D0
D7
D6
D5
D4
D3
D2
D1
D0
LOW (0)
LINE STEREO OFF
16:9 not functional during zoom in
the A/V mode (NORMAL-ZOOM)
CHILD LOCK OFF
CH Up/down functional in the A/V
mode (SCART Jack)
SOUND-I SYSTEM USED
HIGH (1)
LINE STEREO ON
16:9 functional during zoom in the
A/V mode (NORMAL-ZOOM-16:9)
CHILD LOCK ON
CH Up/down not functional in the
A/V mode (RCA Jack)
SOUND-I SYSTEM NOT USED
TDA8374A
NOT USED
TDA8842
AFT ON (always)
Existing Sharpness level (when
using the TDA6108 RGB AMP)
No Auto Power On
NTSC : 25KHz (NTSC TABLE)
PAL : 50KHz (PAL TABLE)
AFT OFF (after fine tuning)
Sharpness level up (when using the
TDA6107Q RGB AMP)
Auto Power On
NTSC : 25KHz (NTSC TABLE)
PAL : 27KHz (PAL TABLE)
Application MICOM
BASIC : LOW
IC201 (ONE-CHIP) OPTION
FIX : LOW
BASIC : LOW
BASIC : HIGH
BASIC : HIGH
ALL (RF VOL. CURVE)
BASIC : LOW
(AV VOL. CURVE : PAL CURVE)
Initial sound system during the
auto search (All should be set for
the system which is selected dur-
ing the Factory Reset.)
Note : Unavailable during the CB
model in the Byte 0
COLOR SYSTEMD2
0
0
D1
0
1
10
11
SOUND SYSTEM
CK : AUTO (No OSD)
CW : -. RF : AUTO→PAL →SECAM→NT4.43
-. A/V : AUTO→PAL→SECAM →NT4.43 →NT3.58
CB : -RF : PAL ONLY (No OSD)
-A/V : AUTO→PAL →NT4.43→NT3.58
CS : - RF : AUTO→PAL →SECAM →NT4.43→NT 3.58
-A/V : AUTO→PAL →SECAM →NT4.43 →NT3.58
(?)→B/G→D/K →
(?)→B/G→D/K → I→
B/G ONLY ( No OSD)
(?)→B/G→D/K → I→
NT → M →
● Function Required : 1. PICTURE OFF (after 15 minutes) during no signal 2. AUDIO MUTE (during no signal)
3. BLUE SCREEN On/Off 4. No Timer Clock On/Off
SYSTEMD1
0
0
D0
0
1
10
11
B/G
D/K
I
? B/G & D/K OR M