12
INSTALLING A REGULAR BOTTLE
Press the fixing lever, lift the exclusive water tank
upwards, then remove it.
Remove the water supply device from the exclusive
water tank, then set the inner groove of the water
supply device in a regular mineral water bottle and
fix it in position by turning it.
Turn the water supply device over, then fix it in
position in the fixing hole.
• Gurgling sounds may be heard when air enters the water tank from regular mineral water or
beverage bottles.
• Some regular mineral water or beverage bottles may not fit the water supply device, depending
on their size.
• If water does not come out satisfactorily when you press the “push” button, press it again.
• Do not use carbonated drinks, such as cola, cider or sodas. When you press the button, the
beverage may spurt out due to the pressure of carbonic gas accumulated in the upper part of
beverage bottle.
• For better hygiene, beverages with a high sugar content (juice, soft drinks) are not
recommended.
• Use bottled mineral water or boiled tap water that does not contain any particles.
Note
DA68-01281A 4/20/03 3:58 PM Page 12
To Next Page
Loading...
Need help?
General
