To Next PageTo Next Page
Need help?Do you have a question about the Samsung DC68-03144B-01 and is the answer not in the manual?
Water level fails to drop below reset level within 15 minutes.
Door fails to unlock after 7 attempts.
Fault in water level sensor, level at or above overflow.
Unbalance or cabinet bump detected during final spin.
Door detected as open while trying to lock.
Verifies operation of LEDs, model/software version, and various modes.
Instructions for safe repair and replacement of parts, including static discharge.
Steps to diagnose and resolve issues when the washer does not start.
Checks for leaks from inlet hoses, standpipe, and internal connections.
Diagnosing issues related to the drum not tumbling during cycles.
Steps to troubleshoot problems where the washer fails to spin.
Diagnosing issues preventing water from filling the tub.
Addressing problems caused by excessive suds formation during washing.
Causes and solutions for clothes remaining too wet after the cycle.
Troubleshooting the door lock mechanism failing to engage.
Diagnosing issues where the door fails to unlock after a cycle.
Resolving issues where control panel buttons do not respond.
Steps to fix problems where the washer does not drain water properly.
Diagnosing incorrect hot/cold water temperatures during cycles.
Identifying causes of excessive noise, vibration, or movement.
Resolving unresponsive buttons, including Child Lock and End display.
Verifies Hall sensor, motor resistance, and drain pump voltage.
Checks water valve voltage, AC power, and heater relay operation.
Checks AC voltage for the door lock coil and connections.
Checks voltage and engagement for the thermistor component.
Verifies voltage and frequency for the water level sensor.
General