44
Ⅳ.ADJUSTMENT
4) Full Version of Firmware1
How to use the FULL version of Firmware1
When the camera is not turned on, do the Full version upgrade.
▷ Camera Status : When turning on the camera, the power consumption (Checking the POWER SUPPLY) is 200-
300mA and the camera can ’t be operated.
▷ Cause : The data of “0” address in the FLASH MEMORY of the MAIN PCB is damaged.
▷ Solution : Recover the address by doing the FULL VERSION FIRMWARE shown below.
▷ Additions : After completing the upgrading of the FULL VERSION FIRMWARE,
do the LENS SHADING and CCD DEFECT CELL adjustment.
1.Short the 3 point of the MAIN PCB as shown.
2. Assemble the camera correctly and insert the SD card that has the Full version of firmware.
3. Turn on the camera by using the Power Supply.
To connect the camera and Power Supply, use the Battery Tool.
4. If the Current is up to 200mA and down to 0 on the POWER SUPPLY display, the upgrade is complete.
To Next Page
Loading...
