To Next PageTo Next PageWhy is my Samsung DV393ETPARA/A1 not heating up?
If your Samsung Dryer isn't heating, check the home’s circuit breaker and fuses. If you have a gas dryer, ensure the gas supply is on. Clean the lint filter and exhaust duct. Also, the dryer may have moved into the cool-down phase of the cycle.
Why is my Samsung DV393ETPARA/A1 Dryer so noisy?
If your Samsung Dryer is noisy, check the load for objects such as coins, loose buttons, or nails, and remove them. It is normal to hear the dryer gas valve or heating element cycle on and off. Ensure the dryer is leveled properly according to the installation instructions. It's also normal for the dryer to hum due to air moving through the drum and exhaust system.
What to do if my Samsung DV393ETPARA/A1 will not start?
If your Samsung Dryer won't start, check the following: * Ensure all wires are correctly connected to their terminals. * Verify the dryer is plugged in. * Check for a blown fuse or tripped circuit breaker. * Confirm the door switch is functional and the door is closed; look for error code 3. * Make sure the Start/Pause rotary selector dial is functional. * Ensure the Control Board is operational. * Check if the belt is off or broken and if the Belt Cut-off Switch is operating. * Verify the drive motor is functional. * Check motor winding resistance: it should be 2.88 ohms between pin #3 and 4, and 3.5 ohms between pin #4 and 5.
Why is my Samsung Dryer so noisy and vibrating?
Excessive noise and vibration in your Samsung Dryer can stem from several issues: * **Thumping:** Check for loose tumbler baffles, worn or misaligned rear tumbler rollers, an out-of-round tumbler, or a high weld seam on the tumbler. * **Ticking:** Look for loose wire harnesses or objects caught in the blower wheel area. * **Scraping:** Inspect the front or rear bulkhead felt seal for being out of position or worn tumbler front bearings. * **Roaring:** Check if the blower wheel is rubbing on the blower housing or if the motor bearings are bad. * **Popping or squealing:** Examine the belt for being sticky or frayed.
Why does my Samsung Dryer keep blowing fuses or tripping the circuit breaker?
If your Samsung Dryer is blowing fuses or tripping the circuit breaker, check the following: * Ensure the belt is properly connected. * Verify the motor winding is continuous (rotor winding, stator winding, generator). * Check if the motor protector is functioning normally. If these checks do not reveal the issue, the PCB assembly may be faulty and require replacement.
Why does my Samsung DV393ETPARA/A1 run for a few minutes and then stop?
Your Samsung Dryer might stop after running for a few minutes due to: * Lint buildup around the drive motor. * Low voltage. * A blocked blower impeller in the blower housing. * Drive motor start switch contacts stuck closed.
What to do if my Samsung DV393ETPARA/A1 Dryer doesn't run?
If your Samsung Dryer doesn’t run, make sure the door is latched shut and the power cord is plugged into a live electrical outlet. Check the home’s circuit breaker and fuses. If the door was opened during the cycle, press the Start/Pause button again.
How to prevent lint on clothes in my Samsung DV393ETPARA/A1?
To prevent lint on clothes when using your Samsung Dryer, clean the lint filter before every load. For loads that produce a lot of lint, clean the filter during the cycle. Separate lint producers (like fuzzy white cotton towels) from lint trappers (like black linen pants). Divide larger loads into smaller ones, and check pockets thoroughly before washing and drying.
Why is my Samsung DV393ETPARA/A1 motor running but not heating?
If your Samsung Dryer's motor runs but doesn't heat, it could be due to: * An open heating element. * The Hi-Limit tripping easily or being open. * The regulating thermostat tripping easily or being open. * An open membrane switch. * A faulty thermistor.
What to do if the motor runs but the tumbler won't turn on my Samsung DV393ETPARA/A1?
If the motor in your Samsung Dryer is running, but the tumbler isn't turning, it could be due to: * The belt being off, broken, or damaged. * The idler tension spring being too weak or stretched. * The idler pulley being jammed or stuck.
Ultra drying capabilities and larger capacity for faster, wrinkle-free results.
Automatic error monitoring system for quick diagnosis and solutions.
Reduces odors/wrinkles with steam; sanitizes garments with high heat.
13 automatic cycles with Fuzzy Logic for precise drying based on dampness.
Includes Time Saving, Energy Saving, Reversible Door, optional Pedestal, and Stacking.
Electric models only: Exhaust vent can be installed in four positions: back, side, bottom.
Covers fire risks, essential safety symbols, and general precautions for safe operation.
Provides gas safety procedures, California Prop 65 warnings, and appliance maintenance safety.
Covers general requirements, dryer exterior, and ducting needs.
Details location, alcove/closet, mobile home, and exhaust requirements.
Guides on gas requirements, electrical needs, grounding, and wiring connections.
Lists installation tools, parts, general procedures, door reversal, and hose connection.
Explains the layout and functions of the dryer's control panel, buttons, and display.
Guides on selecting cycles, dry levels, and using features like My Cycle and Delay Start.
Covers Smart Care, Rack Dry, cleaning the lint filter, and proper loading.
Instructions for cleaning the control panel, tumbler, and dryer exterior.
Recommends annual inspection and cleaning of the exhaust system for optimal performance.
Advice for drying specific items and a list of items to avoid putting in the dryer.
Addresses common issues like not running, not heating, or uneven drying with solutions.
Lists error codes displayed on the panel and their meanings/solutions.
Provides a fabric care chart and technical specifications for the dryer.
Details cycles, recommended items, functions, options, and load size recommendations.
Details the limited warranty period, terms, and exclusions for U.S. purchasers.
Outlines the limited warranty period and terms for Canadian purchasers.
Provides contact information for customer support and online resources.
General
