Samsung DV6000R - Safety Instructions; Caution for Safety During Servicing

Safety Instructions _ 3
1. SAFETY INSTRUCTIONS
1-1. CAUTION FOR SAFETY DURING SERVICING
1. Do not allow the customer to repair the product.
4 The person may be injured or the product life may be shortened.
2. Execute service after unplugging the power supply unit.
4 Be careful of the electric shocks.
3. Do not plug several plugs in the same outlet.
4 Itmaycauseareduetooverheat.
4. Check for damage, pinching or burning of the power plug the outlet.
4 Replaceitpromptlyifithasaproblem.(Itmaycausetheelectricshocksorre)
5. Do not clean the main body with water.
4 Itmaycauseelectricshocksandreandshortentheproductlife.
6. The wiring harness shall be free from moisture and tightened during serving.
4 It shall not be deviated by certain impact.
7. Remove any dust or dirt on the housing section,wiring section,connection section during servicing.
4 Protectfrompossiblecauseofresuchasthetracking,shortageetc.
8. Check for any marks of moisture on the electrical parts, harness section etc.
4 Replace the parts or remove the moisture.
9. Check the assembly status of the parts after servicing.
4 Maintain the status before servicing.
10. Pull out the power cord by holding the plug.
4 Be careful of electric shocks and when the cord is damaged.
11. Unplug the power plug from the outlet when the dryer is not used.
4 Becarefulofelectricshocksandreduetothestrikeoflightning.
12.Donotuseorstorespraysorammablematerials(includinggasoline,alcoholetc.)aroundthedryer.
4 Becarefulofexplosionsorreduetoelectricsparks.
13. Do not put bowls of water or wet laundry on the dryer.
4 Ifwaterhaspenetratedintothedryer,thismaycauseelectricshocksorre.
14. Do not install the dryer outside exposed to moisture.
4 Itmaycauseelectricshocksandreandshortentheproductlife.
15. Do not push the control buttons with an awl,pin, or sharp materials.
4 It may cause electric shocks and damage.
16.Checkthedryerisleveledhorizontallyandinstalledproperlyontheoor.
4 The vibration may shorten the product life.
17. Operate time dry for 20 minutes after service and check wheter HE error occurs or not.
When HC error occurs, check the terminal wiring of compressor.
4 It may cause desorption phenomenon of the pin for the wiring of compressor.