Samsung DW60A806 Series - Page 10

English10
Before you start
Before you start
NOTE
How water softener regeneration works (ECO cycle with H3 level setting)
• Operates for about 2.5 minutes when drying starts and use 2.25 L water (consist 0.25 L
remain in the fresh water tank), 0.0002 kWh energy.
• Regenerates once every 5 cycles
How to set the softener level
The dishwasher is designed to allow for adjusting the amount of salt consumed based on
the hardness of the water used. This is intended to optimise and customise the level of salt
consumption so that the salt consumption could be set proceed as follows:
The buttons used to enter the setting mode may vary depending on the model.
Check the buttons for your model.
1. Turn the dishwasher on.
2. Press and hold the AUTO cycle button for ve seconds within 60 seconds from turning
on the dishwasher.
- When you entered the Setting mode, the display will show “0:00”.
3. Press the Delay Start button to select the water hardness level setting menu.
- The display shows the current setting. (Default setting: “H3”)
4. Press the AUTO cycle button to change the setting.
- You can select from H1 – H6 (soft – hard).
5. Wait 5 seconds to save the setting.
DW8500AM_WEB_Dishwaser_Global_00_EN.indd 10 2021-01-04  6:12:32