English8
Before you start
Before you start
3. Close the rinse aid reservoir cap.
Rinse aid level setting
You can change the amount of rinse aid applied during a cycle.
1. Press the Sanitize button to select the rinse aid level setting menu.
- The display shows the current setting. (Default setting: “d4”)
2. Press the AUTO cycle button to change the setting.
- You can select from d1-d5 (minimum-maximum).
3. Wait 5 seconds to save the setting.
NOTE
• The dishwasher may not wash well if there is not much detergent. For normally
soiled items, we recommend 20-25 grams; however, this may differ depending on the
detergent manufacturer, so please follow that manufacturer’s recommendations.
• If the setting level of the water softener is too low, this can cause a white lm or spots
inside the dishwasher or on the surface of the container.
DW8500AM_WEB_Dishwaser_Global_00_EN.indd 8 2021-01-04 6:12:32
To Next Page
Loading...
