Standard Disassembly Drawings _ 19
Part Figure Description
DOOR HINGE /
GUIDE HINGE
(DW6*R70**BB)
B
A
[DISASSEMBLY]
1. Remove 8 screws that connect the ASSY
CONTROL PANEL to the dishwasher’s DOOR with
Torx® T15 screwdriver.
- Type A: DD81-02756A / 2 pcs
- Type B: DD81-02758A / 6 pcs
Warning
Be sure to remove the power plug before servicing.
Caution
The screws can fall into the SUMP after
disassembly
. Keep the screws to other place to
reassemble the DOOR.
2. Remove wire connector that connect MAIN PBA to
TOUCH PBA.
C
3. Remove 6 screws to take off DOOR OUTER.
NOTE :
Screws on DOOR are Torx® T15 type. Use the
Torx® T15 screw driver when release the screws.
- Type C: DD81-02757A / 6 pcs
Caution
The screws can fall into the SUMP after
disassembly. Keep the screws to other place to
reassemble the DOOR.
Hook
Hook
4. Remove 2 terminals that connected to
DETERGENT DISPENSER, and 1 ground wire that
connected to BRACKET DOOR FRAME.
Warning
Be sure to remove the power plug before
servicing.
Caution
Pay attention to hook of terminals.
To Next Page
Loading...
