To Next PageTo Next PageWhy is there water standing in the bottom of my Samsung Dishwasher?
It is normal for a small amount of clean water to remain around the outlet on the tub bottom of your Samsung Dishwasher to keep the water seal lubricated.
How to fix a Samsung DW80J3020 that does not start?
If your Samsung Dishwasher doesn't start, ensure the door is fully latched and closed, and the upper rack is correctly aligned with the duct nozzle, ensuring no imbalances. Also, verify the dishwasher is powered on, the power cord is properly connected to the wall outlet, and the water supply is correctly connected and turned on. Check that the Control Lock is not activated, a cycle is selected, the circuit breaker is reset, and the fuse is replaced, disconnecting other appliances from the same circuit.
What to do if Samsung DW80J3020 is not cleaning properly?
If your Samsung Dishwasher leaves food particles on dishes, ensure you've selected the correct cycle for the soil level, are using enough dishwasher detergent, and that your water pressure is between 20 and 120 psi (140 ~ 830 kPa). Also, ensure the dishes are loaded properly so they do not interfere with the spray arm and dispenser operation, and that the water temperature is at least 120 °F (49 °C).
Why is my Samsung DW80J3020 so noisy?
If your Samsung Dishwasher is too noisy, ensure it is level. Reload the dishes according to the user manual. Note that some noise is normal when the dispenser cover opens and the drain pump operates early in the cycle. Check for loose utensils or small objects in the basket and secure them. If the dishwasher hasn't been used regularly, run a fill and pump-out cycle weekly to keep the seal moist.
Why is my Samsung Dishwasher not drying dishes well?
If your Samsung Dishwasher isn't drying dishes well, check the rinse aid dispenser and add rinse aid, ensuring the rinse aid setting is correct. Unload the lower rack first, then the upper, to prevent water spillage from concave bottoms. Connect the water supply line to a hot water supply and use rinse aid with the Sanitize option. Ensure dishes are loaded properly, as overloading can affect drying. If, after drying, the inside of the dishwasher and the dishes do not feel warm, call for service.
What to do if my Samsung DW80J3020 Dishwasher leaves food particles on dishes?
If your Samsung Dishwasher has food particles remaining on dishes, ensure you've selected the correct cycle for the soil level of the dishes. Use enough automatic dishwasher detergent (powder or gel). The water pressure must be between 20 - 120 psi (140 - 830 kPa). Rearrange the dishes for good water access, ensuring they don't interfere with the spray arm and dispenser. Connect the water supply line to a hot water supply; the water should be 120 °F (49 °C). If the water is too hard, use a commercial dishwasher cleaner or high-quality detergent with rinse aid.
Why are there suds in my Samsung Dishwasher?
If your Samsung Dishwasher has suds in the tub, it could be due to using the wrong detergent. Use only dishwasher detergent to avoid suds. You can open the dishwasher to let the suds evaporate, add 1 gallon of cold water to the tub, close and latch the dishwasher, then start the Quick+ cycle to drain the water, repeating if necessary. Also, make sure to wipe up any spilled rinse aid immediately.
What to do if water remains in Samsung DW80J3020 Dishwasher after cycle?
If you find water remains after a cycle has finished in your Samsung Dishwasher, it may be due to a bent or clogged drain hose. Contact a qualified service technician to remove any obstruction from the drain hose.
Why does my Samsung DW80J3020 Dishwasher take so long to wash?
If your Samsung Dishwasher takes too long to complete a cycle, ensure the water supply line is connected to a hot water source, as cold water requires additional heating time.
Why is there white coating on cutlery in my Samsung Dishwasher?
If your Samsung Dishwasher has a white coating on the cutlery or crockery, ensure the salt fill indicator and softener setting of your water softener are correct for your area's water hardness. Also, make sure the salt reservoir cap is correctly fitted.
General| Style | Built-In |
|---|---|
| Color | Stainless Steel |
| Load Capacity | 15 Place Settings |
| Number of Cycles | 4 |
| Cycle Selections | Soak |
| Options/Settings | 2 (1-Hour Wash Cycle |
| Drying Type | - |
| Temperature Options | 2 |
| Noise level | 48 dB(A) |
| Special Features | Soil Sensor |
| Energy Class | - |
| Annual Energy Consumption | 265 kWh |
| Energy Consumption Per Cycle | 0.90 kWh |
| Annual Water Consumption | - |
| Water Consumption Per Cycle | - |
| Voltage | 115 V |
| Frequency | 60 Hz |
| Current | 15 A |
Weight and Dimensions| Depth | 24 3/4 in |
|---|---|
| Height | 33 7/8 - 35 7/8 in |
| Width | 23 7/8 in |
| Net Weight | 108 Lbs |
